Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
Remember to double all of your instructions to make both earrings.
- On to your head pin, thread an 8mm round Austrian crystal, a bead cap, the angel's wings, a 6mm round Austrian crystal, and a heishe spacer.
- Create a wrapped loop on your head pin and trim off excess wire.
- Open the loop on your earring hook the way you would open a jump ring, and thread it through your wrapped wire loop. Close the loop again.
WHAT YOU'LL NEED: (scroll down for purchase options)
- FEA-3010 - 22K Gold Plated Surgical Steel Hypo-Allergenic Earring Hooks (100)
Project uses 2 pieces. You will need 1 package.
- FHP-5220 - 22K Gold Plated Head Pins - 21 Gauge - 2 Inches (50)
Project uses 2 pieces. You will need 1 package.
- BMB-5201 - 22K Gold Plated Heishe Spacers 4mm Beads (100)
Project uses 2 pieces. You will need 1 package.
- BMB-3371 - TierraCast 22K Gold Plated Pewter Angel Wing Beads 14mm (4)
Project uses 2 pieces. You will need 1 package.
- BMB-3633 - TierraCast 22K Gold Plated Pewter Bell Flower Bead Caps 10mm (x 2)
Project uses 2 pieces. You will need 1 package.
- SWC-0808 - Austrian Crystal, 5000 Round Beads 8mm, 8 Pieces, Crystal Golden Shadow
Project uses 2 pieces. You will need 1 package.
- SWC-0608 - Austrian Crystal, 5000 Round Beads 6mm, 10 Pieces, Crystal Golden Shadow
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece