Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
These instructions will give you a finished necklace that is about 22 1/2 inches in length.
- Cut off 30 inches of beading wire. Place a bead stopper about 3 inches from one end.
- Onto the beading wire string the pearls in this order: 15 - 6mm pearls, 11 - 8mm pearls, 13 graduated pearls in order, 11 - 8mm pearls, and 15 - 6mm pearls.
- String on one crimp tube. String the beading wire around one closed jump ring and back down thru the crimp tube. Pull tight. Crimp the crimp tube. Trim the excess wire.
- Add a crimp cover to the tube.
- Move to the other side of the necklace, remove the bead stopper and repeat the last two instructions.
- Open the loop on the back of the spring clasp, same as you would a jump ring, and attach it to one of the closed jump rings. Close the loop.
- All done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- BCP-12049 - Dazzle It! Czech Glass Pearls, 6mm Round, 1 Strand, Gun Metal
Project uses 30 pieces. You will need 1 package.
- BCP-12101 - Dazzle It! Czech Glass Pearls, 8mm Round, 1 Strand, Gun Metal
Project uses 22 pieces. You will need 1 package.
- BCP-12126 - Dazzle It! Czech Glass Pearl Combo, 10-16mm Round, 1 Strand, Gun Metal
Project uses 1 Strand. You will need 1 package.
- FJR-07024 - Jump Rings, Closed 8mm Diameter 18 Gauge, 20 Pieces, Silver Plated
Project uses 2 pieces. You will need 1 package.
- FCL-1560 - Silver Plated Spring Ring Round Clasps 6mm (50)
Project uses 1 piece. You will need 1 package.
- FCR-1215 - Beadalon Silver Plated Crimp Tubes 2x1.8mm 1.3mm ID (75 Beads)
Project uses 2 pieces. You will need 1 package.
- FCR-1053 - Shiny Silver Tone Crimp Bead Covers 3mm (x144)
Project uses 2 pieces. You will need 1 package.
- XCR-5143 - Soft Flex, 21 Strand Fine Beading Wire .014 Inch Thick, 30 Feet, Satin Silver
Project uses 30 inches. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5608 - Xuron 4 In 1 Crimping Pliers - Works On 1, 2 And 3mm Crimps!
- XTL-3000 - Bead Stopper- Stop Beads Sliding Off Stringing Material