Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Cut a piece of chain that is 2 inches. Cut a piece of chain that is 3 inches.
- Open one jump ring. Take the last link of the 2 inch piece of chain and hook it onto the jump ring. Place one green neon bead on to this chain. Hook the last link of this chain on to the open jump ring.
- Take the last link of the 3 inch piece of chain and hook it onto the jump ring. Place one pink neon bead on to this chain. Hook the last link of this chain on to the open jump ring. Close the jump ring.
- Thread this jump ring up and over the earring finding to the loop at the bottom.
- For the other earring simply replace the green bead with the yellow bead and replace the pink bead with the orange bead.
WHAT YOU'LL NEED: (scroll down for purchase options)
- BCP-13010 - Czech Glass Large Hole Round Ring Beads 14mm - Bright Neon Mix (4 Pieces)
Project uses 4 pieces. You will need 1 package.
- FJR-5140 - Silver Plated Open Jump Rings 4mm 21 Gauge Thick (100)
Project uses 2 pieces. You will need 1 package.
- FEA-6700 - Silver Plated Earring Hooks Kidney Wires 25mm (10 Pairs)
Project uses 2 pieces. You will need 1 package.
- CHA-2400 - Silver Plated 2mm x 2.4mm Cable Chain - By The Foot
Project uses 10 inches. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers