Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
Remember to double these directions to make your matched pair of earrings.
- Onto a 3" silver plated ball head pin, place 1 small flower bead cap, 1 Austrian crystal crystal faux pearl in rose peach, and another small flower bead cap.
- After the last bead cap, create a simple wire loop. Cut off excess wire with flush cutters.
- Open that simple wire loop (just as you would open a jump ring) and slip the loop beneath your heart stud earring post into it. Close the loop back up.
- All done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- SWP-8092 - Austrian Crystal, 5810 Round Faux Pearl Beads 8mm, 25 Pieces, Rose Peach
Project uses 2 pieces. You will need 1 package.
- FHP-3003 - Silver Plated 2mm Ball Head Pins 21 Gauge 3 Inches (x20)
Project uses 2 pieces. You will need 1 package.
- BMB-6404 - Bright Silver Plated Small Flower Bead Caps 6mm (12)
Project uses 4 pieces. You will need 1 package.
- FEA-1075 - Silver Plated Stud Earring Posts Heart With Loop 6mm (5 Pairs)
Project uses 1 pair. You will need 1 package.
- FEA-1013 - Silver Plated Earring Backs (Earnuts) Med. (100)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5032 - Beadsmith Wire Looping Pliers - Concave And Round Nose