Feelin' the Blues Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by cutting off 12 inches of beading wire and placing a Bead Stopper two inches from one end.
2. Then string on the beads in the following order: 6mm capri blue, 6mm bermuda blue, 6mm capri blue, 4mm crystal labrador. Then repeat this pattern 5 times and end with 6mm capri blue, 6mm bermuda blue and 6mm capri blue.
3. String on one crimp tube. String the wire through one loop of the magnetic clasp and back down through the crimp tube. Crimp the crimp tube. Then add a crimp cover and trim the wire.
4. Move to the other side of the bracelet and repeat the above step.

• FCR-1054 - Shiny Silver Tone Crimp Bead Covers 4mm (x144)
  Project uses 2 pieces. You will need 1 package.


• FCR-1715 - The Beadsmith Crimp Tubes, 2x2mm, 100 Pieces, Silver Plated
  Project uses 2 pieces. You will need 1 package.


• FCL-6808 - Magnetic Clasp, 6x4.5mm, 4 Clasp Sets, Silver Plated
  Project uses 1 piece. You will need 1 package.


• XCR-5493 - Soft Flex, Soft Touch 49 Strand Medium Beading Wire .019 Inch Thick, 30 Feet, Satin Silver
  Project uses 12 Inches. You will need 1 package.


• PCC-2609 - Preciosa Czech Crystal, Round Bead 6mm, 24 Pieces, Capri Blue
  Project uses 14 pieces. You will need 1 package.


• PCC-2608 - Preciosa Czech Crystal, Round Bead 6mm, 24 Pieces, Crystal Bermuda Blue Halfcoat
  Project uses 7 pieces. You will need 1 package.


• PCC-2430 - Preciosa Czech Crystal, Round Bead 4mm, 36 Pieces, Crystal Labrador Halfcoat
  Project uses 6 pieces. You will need 1 package.

• XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire (1 Piece)
• XTL-5608 - Xuron 4 In 1 Crimping Pliers - Works On 1, 2 And 3mm Crimps!