Elite Circle Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut two lengths of chain 7.5 inches each.
2. Open one jump ring and attach it to one end of one piece of chain and to the circle link. Close the jump ring.
3. Open another jump ring and attach it to one end of the second piece of chain and to the circle link. Close the jump ring.
4. Open another jump ring and attach it to the end of the piece of chain you just attached. Close the jump ring.
5. Open the jump ring attached to the clasp and attach the jump ring to the the piece of chain. Close the jump ring.

• CHA-1019 - Gold Filled Delicate Flat Cable Chain 1.5mm Bulk By The Foot
  Project uses 15 Inches. You will need 2 packages.


• FJR-05314 - Gold Filled JUMPLOCK Jump Rings 4mm 20 Gauge (10)
  Project uses 3 pieces. You will need 1 package.


• FCL-2210 - 14K Gold Filled Straight Lobster Clasp 10mm (x1)
  Project uses 1 piece. You will need 1 package.


• FJR-1005 - Round Link Component, Closed 18 Gauge Wire 30mm Diameter, 1 Piece, 14K Gold Filled
  Project uses 1 piece. You will need 1 package.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex