Electric Skull Earrings (Reboot)

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Take one silver plated eye pin and slide on an Austrian crystal skull bead. Create a wrapped wire loop using your round nose pliers. Snip off any excess wire using your flush cutters.
2. Open a silver plated earring hook (how you would a jump ring) and slide it onto the wrapped wire loop at the top of your Austrian crystal skull bead. Close the earring hook.
3. Next, open a silver plated jump ring with your chain nose pliers and slide it onto the eye pin loop at the bottom of your skull bead. Before closing, also slide on the hole from your Austrian crystal spike pendant. Close the jump ring.
4. You're done!

• SWBB-2032 - Austrian Crystal, 5750 Skull Bead 19mm 1 Piece, Crystal Metallic Blue 2X
  Project uses 2 pieces. You will need 2 packages.


• FEA-3025 - Silver Plated Long Elegant Earring Hooks (50)
  Project uses 1 pair. You will need 1 package.


• SWCR-6025 - Austrian Crystal, 6480 Spike Pendant 39mm, 1 Piece, Crystal Bermuda Blue P
  Project uses 2 pieces. You will need 2 packages.


• FJR-5479 - Silver Plated Open Jump Rings 8mm 20 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• FHP-6261 - Silver Plated Open Eye Pins 21 Gauge 2 Inch (x50)
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose