Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below you will make one earring. Repeat all instructions to make the second earring.
- Open one jump ring and attach it to one heart pendant.
- Take one eye pin and string on one pearl. Make a simple wire loop.
- Open one loop of the eye pin, same as you would a jump ring, and attach it to the jump ring on the heart pendant. Close the eye pin.
- Move to the top loop of the eye pin and attach it to one earring hook. Close the loop and you're all done.
WHAT YOU'LL NEED: (scroll down for purchase options)
- FEA-3025 - Silver Plated Long Elegant Earring Hooks 25x16.5mm (50)
Project uses 2 pieces. You will need 1 package.
- FHP-6267 - Silver Plated Open Eye Pins 22 Gauge 2 Inch (x50)
Project uses 2 pieces. You will need 1 package.
- FJR-5467 - Silver Plated Open Jump Rings 6mm 21 Gauge (50)
Project uses 2 pieces. You will need 1 package.
- SWP-4087 - Austrian Crystal, #5810 Round Faux Pearl Beads 4mm, 50 Pieces, Elderberry
Project uses 2 pieces. You will need 1 package.
- SWCR-6458 - Austrian Crystal, #6432 Heart Cut Pendant 10.5mm, 2 Pieces, Rose
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers