Retired - Dragonfly Dance Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut two lengths of chain, 10 1/2 inches each, starting with a large ball and ending with a small ball. Set aside.
2. Cut two lengths of chain, about 3/4 of an inch long, consisting of a small ball, a large ball and a small ball. Set aside.
3. Cut off a large ball without jump rings and set aside.
4. Take one length of chain that is 10 1/2 inches and open one jump ring and attach it to the end with the large ball. Close the jump ring.
5. To the other end of this chain, open a jump ring and attach it to one square connector. Close the jump ring.
6. Open another jump ring and attach the square connector to one length of chain 3/4 long. Close the jump ring.
7. To the other side of the chain connect another square connector with a jump ring.
8. On the other side of the second square connector attach one jump ring. Close the jump ring.
9. Open one more jump ring and attach the single large ball link and attach this jump ring to the jump ring attached to the square connector. Close the jump ring.
10. Open another jump ring, attach the second jump ring from the last step to another square connector. Close the jump ring.
11. Open another jump ring and attach the square connector to one length of chain 3/4 long. Close the jump ring.
12. To the other end of this chain, open a jump ring and attach it to one square connector. Close the jump ring.
13. Open another jump ring and attach the square connector to the other length of chain 10 1/2 inches, to the side with the small ball. Close the jump ring.
14. To the other end of this chain, attach one lobster clasp with a jump ring. Close the jump ring.
15. To attach the dragonfly charm, take one jump ring an attach it to the other side of the single ball connector in the center of the necklace. Close the jump ring.
16. All done!

• SWCR-1171 - Austrian Crystal, 67523 Dragonfly Pave Pendant 18mm, 1 Piece, Peridot / Gold
  Project uses 1 piece. You will need 1 package.


• FCL-4721 - 22K Gold Plated Curved Lobster Clasps 12mm (6)
  Project uses 1 piece. You will need 1 package.


• FJR-5250 - 22K Gold Plated Open Jump Rings 5mm 20 Gauge (100)
  Project uses 12 pieces. You will need 1 package.


• BMB-3549 - TierraCast 22K Gold Plated Pewter 12mm Hammered Square Connectors (4)
  Project uses 4 pieces. You will need 1 package.


• CHA-0416 - Gold Plated Bulk Chain, 7 & 3mm Moroccan Links, Sold By The Foot
  Project uses 24 Inches. You will need 2 packages.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex