Retired - Divine Deco Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Using your flush cutters, cut a 1 inch length of Nunn Design antiqued gold plated chain. Set aside.
2. Next, onto a gold plated ball head pin, slide on a black Austrian crystal artemis cone bead, followed by an Austrian crystal crystal rondelle bead and another black Austrian crystal artemis cone bead. Also slide on the last link from one side of your chain length.
3. Create a wrapped-wire loop with your round nose pliers and snip off any excess with your flush cutters.
4. With your chain nose pliers, open the loop on your earring hook (how you would a jump ring) and slide on the last link from the other end of your chain length and close.
5. That�s it!

• CHA-9814 - Nunn Design Antiqued Gold Plated Oval Cable Chain 3mm By The Foot
  Project uses 2 inches. You will need 1 package.


• FEA-3020 - 22K Gold Plated Fish Hook Earring Hooks (50)
  Project uses 2 pieces. You will need 1 package.


• FHP-3023 - 22K Gold Plated 2mm Ball Head Pins 21 Gauge 3 Inches (x20)
  Project uses 2 pieces. You will need 1 package.


• SWC-2344 - Austrian Crystal, 5540 Artemis Cone Bead 17mm, 1 Piece, Jet
  Project uses 2 pieces. You will need 2 packages.


• SWC-5186 - Austrian Crystal, 9001 Rondelle Beads 10x3.7mm, 2 Pieces, Gold Plate With Crystal
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose