Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Using your nylon jaw pliers, carefully open and remove one of the open link chains from your heavy hammered brass chain length.
- Add a small dab of glue onto the bottom 1/4" mark of your sea glass bead. Carefully slide the chain link down the bead, securing it onto the glue. Close the chain link around the bead, as much as you can without chipping the sea glass bead or nicking the chain. See photo. Set the bead aside to dry for a few minutes.
- Slide on your sea glass bead onto a 3" gold plated head pin. Next slide on a gold plated spacer bead. Create a wire wrapped loop using your round nose pliers. Snip off any excess wire using your flush cutters.
- Next, open a gold plated jump ring using your chain nose pliers and slide on the loop from your hammered gold plated earring finding and also the wrapped wire loop from your bead dangle. Close the jump ring.
- Add a gold plated ear nut to the back of your earring finding and you're done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- CHA-08046 - Raw Brass Bulk Chain, Hammered Heavy Rolo Links 6.5x12.5mm, 1 Foot, Brass
Project uses 2 links. You will need 1 package.
- FEA-1526 - TierraCast 22K Gold Plated Pewter Stud Post Earrings Hammered 13.5mm 1 Pair
Project uses 1 pair. You will need 1 package.
- BGL-10146 - Cultured Sea Glass, Long Teardrop Beads 38x9mm, 5 Pieces, Royal Blue
Project uses 2 pieces. You will need 1 package.
- FHP-05223 - 22K Gold Plated Head Pins - 21 Gauge 3 Inches (25)
Project uses 2 pieces. You will need 1 package.
- FEA-01120 - 14K Gold Filled Earring Backs - Ear Nuts (3 Pairs)
Project uses 1 pair. You will need 1 package.
- BMB-5216 - 22K Gold Plated Thick Heishe Spacers Beads 4.5mm x 2.5mm (144)
Project uses 2 pieces. You will need 1 package.
- FJR-5240 - 22K Gold Plated Open Jump Rings 4mm 21 Gauge (x100)
Project uses 2 pieces. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-0073 - Eurotool Large Double Nylon Jaw Jewelry Pliers - Round Nose