Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below you will make one earring. Repeat all instructions to make the second earring.
- String on one pearl to one headpin. Make a simple wire loop. Trim any excess wire.
- String on one bicone to one eye pin. Make a simple wire loop. Trim any excess wire.
- Open the simple wire loop on the pearl, same as you would a jump ring, and attach it to the simple wire loop of the bicone. Close the loop.
- Move to the other side of the bicone, open the loop and attach it to the loop of the earring hook. Close the loop and you're all done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- FHP-6265 - Silver Plated Open Eye Pins 22 Gauge 1 Inch (x50)
Project uses 2 pieces. You will need 1 package.
- FHP-5314 - Silver Plated Head Pins 1 Inch/22 Gauge (50)
Project uses 2 pieces. You will need 1 package.
- FEA-3025 - Silver Plated Long Elegant Earring Hooks (50)
Project uses 2 pieces. You will need 1 package.
- SWP-1001 - Austrian Crystal, 5810 Round Faux Pearl Beads 10mm, 10 Pieces, White
Project uses 2 pieces. You will need 1 package.
- SWBB-1500 - Austrian Crystal, 5328 Bicone Beads 5mm, 20 Pieces, Crystal
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers