Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below you will make one earring. Repeat all instructions to make the second earring.
- Take one head pin and string on one pearl with the large side facing down. Then string on one bead cap with the large side facing down, and one bead cap with the large side facing up. Finally string on one crystal bead.
- Make a wrapped wire loop. Trim any excess wire.
- Open the lever back of the earring and slide this loop up and over the earring until it sits it the curved well at the base. Close the lever back to wear and you're all done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- SWC-0400 - Austrian Crystal, 5000 Round Beads 4mm, 12 Pieces, Crystal
Project uses 2 pieces. You will need 1 package.
- SWP-1101 - Austrian Crystal, 5821 Pear Shaped Faux Pearl Beads 11mm, 4 Pieces, White
Project uses 2 pieces. You will need 1 package.
- BMB-3827 - TierraCast Silver Plated Pewter Beaded Bead Caps 4mm (20)
Project uses 4 pieces. You will need 1 package.
- FEA-6018 - Silver Plated Earring Findings Leverbacks 17x9mm (5 Pairs)
Project uses 2 pieces. You will need 1 package.
- FHP-5320 - Silver Plated Head Pins 2 Inches Long/22 Gauge (X50)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers