Retired - Christmas Candy Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Start by removing the jump ring from your candy charm. You will not need it for this project, but keep it around for another project at a future date.
2. Place a bicone onto an eye pin. Create a simple wire loop after the bead.
3. Open the simple wire loop and attach it to the loop at the top of your charm. Close the loop back up.
4. On the other side of your bead, open that simple wire loop and link onto your earring hook. Close the loop back up.
5. Happy Holidays!

• FEA-3015 - Silver Plated Fishhooks Earring Hooks (50)
  Project uses 2 pieces. You will need 1 package.


• BCZ-5601 - Preciosa Czech Crystal Beads 6mm Bicone 'Crystal AB' Clear (20)
  Project uses 2 pieces. You will need 1 package.


• FHP-6261 - Silver Plated Open Eye Pins 21 Gauge 2 Inch (x50)
  Project uses 2 pieces. You will need 1 package.


• PND-8101 - Silver Plated Enamel Charm Green Peppermint Candy 16mm (1)
  Project uses 1 piece. You will need 1 package.


• PND-8100 - Silver Plated Enamel Charm Red Peppermint Candy 16mm (1)
  Project uses 1 piece. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex