Retired - Chanted Om Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Using your flush cutters, cut off 16 inches of chain.
2. Open one jump ring and attach it to the last link of one end of the chain. Close the jump ring.
3. Open another jump ring and attach it to the other end of the chain, and add a lobster clasp. Close the jump ring.
4. Open one more jump ring and attach it to the loop of the charm and around the center of the chain. Close the jump ring. This charm should move freely, however if you like you can attach it to a link in the center of the chain so it remains in one spot.
5. All done!

• CHA-99956 - Antiqued Copper Plated Slim Rolo Chain 2mm Bulk By The Foot
  Project uses 16 Inches. You will need 2 packages.


• FCL-1124 - Lobster Clasp, 10x6mm, 20 Pieces, Antiqued Copper
  Project uses 1 piece. You will need 1 package.


• FJR-5293 - Genuine Antiqued Copper Open Jump Rings 4mm 21 Gauge (100)
  Project uses 3 pieces. You will need 1 package.


• PND-3308 - Nunn Design Itsy Charm, Om Ohm Aum 9mm, 1 Piece, Antiqued Copper Plated
  Project uses 1 piece. You will need 1 package.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex