Retired - Cady Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. For a 6 1/2 inch bracelet, cut two lengths of cord 7 1/2 inches each.
2. For this next technique, please watch our video: How to Make a Looped Climbing Bracelet. From what you learned in the video, line up the two cords, side by side, and about 3 inches in towards the center, begin the wrap of the super-lon cord using the E6000 on the back side to secure it into place. Wrap until you have just under 1 inch. Tie off and trim the super-lon cord.
3. Take one cord end and place a few drops of Super New Glue into the recess. Place both ends of one side into the cord end.
4. Repeat on the other side. Be sure to let the ends dry completely before attempting to clasp them. The magnet is strong and could pull the cord out until it dries properly.

• XCR-4007 - Multi-Colored Cotton Cord, Round Woven Strands 6mm Thick, 3 Feet, Black / Pink Mix
  Project uses 15 Inches. You will need 1 package.


• FCL-1681 - Regaliz Findings, Round 2-Strand Magnetic Clasp Fits 5mm Round Cord, 1 Set, Antiqued Silver
  Project uses 1 piece. You will need 1 package.


• XCR-4244 - BeadSmith Super-Lon Cord - Size 18 Twisted Nylon - Purple / 77 Yard Spool
  Project uses 1 Spool. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.


• XTL-1059 - Eurotool Super New Glue - Heavy Duty Adhesive - 3 Gram Bottle
  Project uses 1 piece. You will need 1 package.

• XTL-5500 - Cord Cutter Tool For Regaliz Cord 3 Inches Long
• XTL-5700 - Fiskars 5 Precision Tip Scissors - Super Sharp