Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Cut off 6" of beading wire and place a bead stopper about 2" from one end.
- Thread onto the wire 1 gold crimp tube, 15 gold seed beads, 9 Czech glass peacock beads and 15 gold seed beads.
- Thread the end of the wire through the crimp tube forming a loop with the wire. Remove the bead stopper.
- Now that you have both ends of your wire going up through the crimp tube, pull them tight and loop both tails through the front of the earring finding and back down through the crimp tube. Crimp the crimp tube. Snip off the tails of the remaining wire.
- Place a crimp cover over the crimp tube. Close the crimp cover.
- All you have left is to add an earring back to your earring and you are ready to wear it.
WHAT YOU'LL NEED: (scroll down for purchase options)
- BCP-08221 - Czech Pressed Glass 5 x 16mm Dagger Beads - Peacock Turquoise (25)
Project uses 18 pieces. You will need 1 package.
- JSK-0277 - Toho Round Seed Beads 11/0 PF557 'Galvanized Starlight' 8g
Project uses 60 pieces. You will need 1 package.
- XCR-67543 - Beadalon Wire Satin Gold 7 Strand .015 Inch / 30Ft
Project uses 1 Foot. You will need 1 package.
- FEA-1501 - TierraCast 22K Gold Plated Pewter Stud Earrings Dome Post & Ring 8mm
Project uses 2 pieces. You will need 1 package.
- FCR-1206 - Beadalon Gold Plated Crimp Tubes 1.5mm (65 Beads)
Project uses 2 pieces. You will need 1 package.
- FCR-1056 - Bright Gold Tone Crimp Bead Covers 3mm (144)
Project uses 2 pieces. You will need 1 package.
- FEA-01120 - 14K Gold Filled Earring Backs - Ear Nuts (3 Pairs)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5230 - Double Notch Crimping Pliers - Works on 2mm And 3mm Crimps
- XTL-3000 - Bead Stopper- Stop Beads Sliding Off Stringing Material