Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below you will make one earring. Repeat all instructions for the second earring.
- Take one head pin and a pair of round nose pliers, create a small spiral of three coils near the ball end. Thread the head pin with the coils on the end up through one orange petal and one black petal facing down.
- Make a wrapped wire loop. Trim the excess wire with your flush cutters.
- Open the loop of the earring finding, same way you would a jump ring. Attach the earring finding to the wrapped wire loop. Close the loop.
- All done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- FEA-3000 - Surgical Steel Earring Hooks Hypo-Allergenic (x100)
Project uses 2 pieces. You will need 1 package.
- BCP-40068 - Lucite Trumpet Calla Lily Flower Beads Matte Orange 10mm (12)
Project uses 2 pieces. You will need 1 package.
- BCP-40078 - Lucite Trumpet Calla Lily Flower Beads Matte Black 12mm (10)
Project uses 2 pieces. You will need 1 package.
- FHP-3047 - Gun Metal Plated 2mm Ball Head Pins - 22 Gauge Thick 3 Inches Long (20)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers