Retired - Aquamarine Shimmer Sterling Silver Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by stringing one bicone onto one head pin. Make a wrapped wire loop. Set aside. Repeat five more times.
2. Open the wire loop same as you would a jump ring and attach it to one loop on the bottom of the chandelier frame. Close the loop. Repeat for the other four loops on the bottom. Then repeat to attach one to the jump ring in the center of the frame.
3. Open the loop of the earring post and attach it to the top loop of the chandelier frame. Close the loop and you're all done.

• FEA-01041 - Sterling Silver Earrings Ball Post & Ring 4mm (6)
  Project uses 2 pieces. You will need 1 package.


• FEA-8440 - Sterling Silver Teardrop Chandelier Earrings Findings 40mm
  Project uses 1 Pair. You will need 1 package.


• FHP-02315 - Sterling Silver Head Pins 22 Gauge 1.5 Inch (10)
  Project uses 12 pieces. You will need 2 packages.


• SWBI-16620 - Austrian Crystal, 5328 Bicone Beads 6mm, 20 Pieces, Aquamarine Shimmer
  Project uses 12 pieces. You will need 1 package.


• FEA-1016 - Bullet Clutch Earring Backs, Hypo Allergenic with Pad 7x12mm, 50 Pcs, Silver
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers