Retired - Anya Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by taking one eye pin and stringing on one chrysolite opal rondelleone pacific opal rondelle, and one chrysolite opal rondelle. Make a simple wire loop that faces perpendicular to the loop on the other end of this eye pin. It will also need to be a larger loop to accommodate the emerald cut pendant. Achieve this by making your loop closer to the fulcrum of the round nose pliers.
2. Open the loop same as you would a jump ring to attach the emerald cut pendant.
3. Finally open the loop at the top and attach it to the earring lever back hook.

• SWC-56602 - Austrian Crystal, #5040 Rondelle Beads 6mm, 10 Pieces, Pacific Opal Shimmer 2X
  Project uses 2 pieces. You will need 1 package.


• SWC-56600 - Austrian Crystal, #5040 Rondelle Beads 6mm, 10 Pieces, Chrysolite Opal Shimmer 2X
  Project uses 4 pieces. You will need 1 package.


• SWCR-6702 - Austrian Crystal, #6435 Emerald Cut Pendant 11.5mm, 2 Pieces, Crystal Shimmer
  Project uses 2 pieces. You will need 1 package.


• FHP-6261 - Silver Plated Open Eye Pins 21 Gauge 2 Inch (x50)
  Project uses 2 pieces. You will need 1 package.


• FEA-6018 - Silver Plated Earring Findings Leverbacks 17x9mm (5 Pairs)
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
• XTL-5511 - The Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - The Beadsmith Jewelry Fine Round Nose Micro Pliers