Retired - Antiqued Clover Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut a 1 inch length of leaf charm chain.
2. Open the loop of an eye pin the same way you would open a jump ring and slide on the top link of the length of leaf charm chain. Close the loop.
3. Slide the eye pin through one hole of one magnesite clover bead. Then string three round brass beads onto the eye pin (it will be snug, but they will fit inside the clover bead). Then exit the top hole of the clover bead with the eye pin.
4. Make a simple wire loop and clip off the excess wire with flush cutters.
5. Open the loop of one earring hook and slide on the wire loop of the eye pin from the previous step. Close the loop.
6. Enjoy your earrings!

• SPMA-96 - Turquoise Blue Magnesite (Dyed) Open Clover / Flower Shaped Beads 20mm (10)
  Project uses 2 pieces. You will need 1 package.


• BMB-5180 - Antiqued Brass Balloon 4mm Round Beads (100)
  Project uses 6 pieces. You will need 1 package.


• FHP-6282 - Antiqued Brass Open Eye Pins 21 Gauge 1.5 Inch (x50)
  Project uses 2 pieces. You will need 1 package.


• FEA-6640 - Vintaj Natural Brass Round Loop Ear Wire 25mm (2 Pair)
  Project uses 2 pieces. You will need 1 package.


• CHX-2009 - Antiqued Brass 7mm Leaf Charm Chain - Bulk By The Inch
  Project uses 2 inches. You will need 2 packages.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex