Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
This design measure approximately 6.5 inches. To adjust the length, simply modify the number of beads strung.
- Open one jump ring and attach it to the charm. Close the jump ring and set aside.
- Cut 10 inches of beading wire and add a bead stopper about two inches from one end.
- String the beads in the following order: 5 gemstones, 1 lotus (facing out from center), 3 gemstones, 1 bead cap (facing out from center), 1 jump ring with charm, 1 bead cap (facing out from center), 3 gemstones, 1 lotus (facing out from center), and 5 gemstones.
- Then string on crimp bead. String the wire up and around one loop of the magnetic clasp. Using crimping pliers, crimp the tube as seen in our video: How to Use Crimp Beads and Tubes. Trim any excess wire.
- Remove the bead stopper from the other side, and repeat the above process to finish the bracelet.
WHAT YOU'LL NEED: (scroll down for purchase options)
- SPMA-110 - Dakota Stones Gemstone Beads, Green Malachite, Round 8mm, 8 Inch Strand
Project uses 16 pieces. You will need 1 package.
- BMB-065 - Metal Bead, Lotus Flower Design 7x11.5mm, 2 Pieces, Antiqued Copper Plated, By TierraCast
Project uses 2 pieces. You will need 1 package.
- BMB-060 - Bead Cap, Hammertone 7.5mm, 2 Pieces, Antiqued Copper Plated, By TierraCast
Project uses 2 pieces. You will need 1 package.
- PNT-273 - Metal Charm, Blossom Hand with Flower 27mm, 1 Piece, Antiqued Copper Plated, By TierraCast
Project uses 1 piece. You will need 1 package.
- FCL-115 - Magnetic Clasp, Lotus 14x20.5mm, 1 Set, Antiqued Copper Plated, By TierraCast
Project uses 1 piece. You will need 1 package.
- FJR-9118 - TierraCast Pewter, Small Open Jump Rings 5.4mm, 50 Pieces, Copper Plated
Project uses 1 piece. You will need 1 package.
- XCR-69833 - Beadalon Wire Satin Silver 19 Strand .018 Inch / 30Ft
Project uses 10 Inches. You will need 1 package.
- FCR-4314 - The Beadsmith Magical Crimp Tube Beads, 2x2mm, 100 Pieces, Copper Plated
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5514 - The Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5511 - The Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-7206 - The Beadsmith Magical Crimping Pliers, Transforms 2mm Tubes into Round Beads, 1 Piece
- XTL-3000 - Bead Stopper- Stop Beads Sliding Off Stringing Material