Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
In addition to the materials listed above, you will also need a paint brush to complete this project. These instructions will make a 16 inch necklace; for a longer or shorter necklace, adjust the length of chain used.
- First, watch our video on how to use Vintaj patinas. Use a dry paint brush to paint the inside of the Nunn Design bezel with the green patina. Wait a few hours for it to dry.
- Take one gold four-leaf clover charm and remove the attached jump ring with pliers. Use flush cutters to cut off the loop of the charm. File the rough edge until smooth with the Vintaj metal file.
- Place a dab of E6000 glue onto the back of the clover. Then place the clover into the center of the bezel and press so it sticks. Let the glue dry overnight.
- Cut a 16 inch length of gold chain.
- Open a jump ring. Slide it through the loop of the bezel pendant and also slide it onto the length of chain. Close the jump ring.
- Open another jump ring and slide it onto the last link of chain on one side of the necklace. Also slide on the loop of your clasp. Close the jump ring.
- Open another jump ring and slide it onto the last link of chain on the other side of the necklace. Close the jump ring.
- All finished!
WHAT YOU'LL NEED: (scroll down for purchase options)
- PND-6044 - 22K Gold Plated Small Four-Leaf Clover Charm With Ring - 10.5mm (6)
Project uses 1 piece. You will need 1 package.
- PND-6536 - Nunn Design Antiqued Gold Plated Pewter Collage Circle Bezel 1/2 Inch
Project uses 1 piece. You will need 1 package.
- XTL-9065 - Vintaj Patina Opaque Permanent Ink - Jade Green - 0.5 Ounce Bottle
Project uses 1 piece. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
- CHA-99958 - 22K Gold Plated Slim Rolo Chain 2mm Bulk By The Foot
Project uses 16 inches. You will need 2 packages.
- FJR-5240 - 22K Gold Plated Open Jump Rings 4mm 21 Gauge (x100)
Project uses 3 pieces. You will need 1 package.
- FCL-7521 - Nunn Design Antiqued 24kt Gold Plated Lobster Clasps 11.5mm (2)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-2221 - Vintaj Special Edition - Metal File 2 Cut - 3 Long 0.40 Wide