Retired - Vintage Bride Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by separating the channel chain. Open the jump rings and remove them from the links. You will not be using these jump rings for this project.
2. Using your flush cutters cut off two inches of silver chain. To one end attach one channel link using one jump ring.
3. Cut off two more inches of chain. Attach this chain to the other side of the channel link you just added using one jump ring.
4. You will continue in this manner until you have added 21 channel charms.
5. When you come to the final link, attach it to the beginning of the chain to complete the necklace.
6. All done!

• CHA-2010 - Austrian crystal Rhodium Plated Channel Crystal Chain Crystal 6.8mm - BY THE FT
  Project uses 1 Foot. You will need 1 package.


• CHA-9970 - Bright Silver Plated Round Rolo Chain 3mm Bulk By The Foot
  Project uses 42 Inches. You will need 4 packages.


• FJR-3911 - Silver Plated Open Jump Rings 4mm 20 Gauge (50)
  Project uses 42 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex