Retired - Stainless Steel Chain Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. To begin, use heavy duty flush cutters to cut the following lengths of stainless steel chain: 1.5 inches of 2.2mm cable chain, 2 inches of 2.7mm curb chain, 2.5 inches 4x3mm cable chain, 2.25 inches of 2.7mm curb chain, and 1.75 inches of 2.2mm cable chain.
2. Use pliers to open a 4mm jump ring, and slide on one end link of each of the chain lengths from step 1 in the order listed. Close the jump ring.
3. Open the loop of your earring hook and slide it onto the jump ring between the 2.2mm cable chains so that the chain lengths fall in the order shown in the photo. Close the loop and you're all done!

• CHA-0377 - Bulk Curb Chain, Flattened Links 2.7x2mm, Sold By The Foot, Stainless Steel
  Project uses 8.5 inches. You will need 1 package.


• CHA-0378 - Bulk Cable Chain, Oval Links 2.2x1.8mm, Sold By The Foot, Stainless Steel
  Project uses 6.5 inches. You will need 1 package.


• CHA-0379 - Bulk Cable Chain, Oval Links 4x3mm, Sold By The Foot, Stainless Steel
  Project uses 5 inches. You will need 1 package.


• FEA-9750 - French Ear Wire, w/ Coil and Loop 21mm, 20 Pieces, Stainless Steel
  Project uses 2 pieces. You will need 1 package.


• FJR-0001 - Jump Rings, Open 3.5mm Diameter 22 Gauge, 50 Pieces, Stainless Steel
  Project uses 2 pieces. You will need 1 package.

• XTL-5603 - CHP Milano Heavy Duty Flush Cutter - Cuts Up To 2.5mm Copper Wire
• XTL-0034 - Wubbers Classic Series Round Nose Quality Jeweller's Pliers
• XTL-0020 - Baby Wubbers Quality Fine Chain Nose Jeweller's Pliers