Retired - Sonoma Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. To begin, use your flush cutters to cut the jump rings in between the links of the Moroccan chain. Cut so that you have 8 large separated links.
2. Open one jump ring and attach one end of the magnetic clasp to one Moroccan chain link. Close the jump ring.
3. Continue by opening and closing jump rings to attach the links in the following order: 1 amethyst, 1 Moroccan link, 1 peridot, 1 Moroccan link; repeat twice followed by 1 more amethyst link and 1 Moroccan link.
4. Then open one more jump ring and attach the other side of the magnetic clasp to the final Moroccan link.

• CHA-0416 - Gold Plated Bulk Chain, 7 & 3mm Moroccan Links, Sold By The Foot
  Project uses 4 Inches. You will need 1 package.


• SWFA-1122 - Austrian Crystal, Gold Plated Channel Connector Link, 7mm, 4 Pieces, Amethyst
  Project uses 4 pieces. You will need 1 package.


• SWFA-1130 - Austrian Crystal, Gold Plated Channel Connector Link, 7mm, 4 Pieces, Peridot
  Project uses 3 pieces. You will need 1 package.


• FCL-6682 - 22K Gold Plated Magnetic Clasps 6mm x 8mm (3)
  Project uses 1 piece. You will need 1 package.


• FJR-3921 - 22K Gold Plated Open Jump Rings Oval 21 Gauge 3x4mm (50)
  Project uses 16 pieces. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers