Retired - Opal Rose Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Remember to double all of the instructions in order to make both earrings! Begin by opening a large copper jump ring. Thread this through the loop at the top of the wooden pendant and close it once more.
2. Open a small copper jump ring and thread it through both the larger jump ring and the loop at the bottom of the earring hook. Close this jump ring again.
3. Spread a tiny amount of E6000 on the bottom of the glass opal cabochon (use a toothpick or a piece of wire) and press it firmly onto the center of the wooden pendant. Allow to dry for at least twenty four hours before wearing.

• SPCB-7002 - Faux Fire Opal Foil Glass Cabochon Round 7mm (2)
  Project uses 2 pieces. You will need 1 package.


• FEA-1536 - TierraCast Niobium Copper Earring Hooks With 2mm Ball Hypo-Allergenic (2 Pair)
  Project uses 2 pieces. You will need 1 package.


• FJR-3080 - Genuine Copper Open Jump Rings 4mm 21 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• FJR-3079 - Bright Copper Open Jump Rings 8mm 18 Gauge (25)
  Project uses 2 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers