Retired - Millionairess Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Place a dab of glue into the bezel earring post. Place an Austrian crystal Flatback into the bezel. Dry in an upright position. Allow to dry fully before moving on.
2. Cut a length of chain 1.5" long. Open one jump ring, and attach one end of the chain to one diamond pendant. Close the jump ring.
3. Move to the other side of this chain, open another jump ring and attach it to the chain and the loop of one of the earring posts. Close the jump ring.
4. When ready to wear attach one earring back to the earring post.

• PND-0311 - Blank Flat Stamping Pendant, Open Diamond Design 20x19.5mm, 1 Piece, Gold Plated
  Project uses 2 pieces. You will need 2 packages.


• SWF-534314 - Austrian Crystal, Round Flatback Rhinestone Hotfix SS34 7mm, 12 Pieces, Crystal Luminous Green
  Project uses 2 pieces. You will need 1 package.


• FEA-1308 - TierraCast Pewter Earring Post, Glue-In Stepped Bezel 16x12mm, 2 Pieces, Gold Plated
  Project uses 2 pieces. You will need 1 package.


• CHX-1240 - GenY Chain, Cable Links 1.5x2mm, 1 Inch, 18K Forever Gold
  Project uses 3 Inches. You will need 3 packages.


• FJR-5240 - 22K Gold Plated Open Jump Rings 4mm 21 Gauge (x100)
  Project uses 4 pieces. You will need 1 package.


• FEA-1017 - Bullet Clutch Earring Backs, Hypo Allergenic with Pad 7x11mm, 50 Pieces, Gold Tone
  Project uses 2 pieces. You will need 1 package.


• XTL-1001 - G S Hypo Cement Precise Applicator Essential!
  Project uses 1 piece. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex