Retired - Midori Splash Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by removing the lucite chain from the card. You will use the entire length of this chain so there is no need to cut or break it.
2. Cut the foot of curb chain into two lengths of 6 inches each.
3. Open one large jump ring and attach one end of the lucite chain to one end of one piece of the curb chain. Close the jump ring.
4. Open one large jump ring and attach it to the other end of the curb chain that you just added. Close the jump ring.
5. Move to the other side of the lucite chain, using one large jump ring, attach the other length of curb chain. Close the jump ring.
6. To the end of the curb chain on this side, attach one large jump ring. Close the jump ring.
7. To the last large jump ring that you just added, open one small jump ring and attach the lobster clasp to this jump ring and attach it to the large jump ring. Close the jump ring.
8. All done!

• CHA-08014 - Gold Plated Bulk Chain, Heavy Flattened Curb Links 9.5x12.5mm, 1 Foot, Bright Gold
  Project uses 1 Foot. You will need 1 package.


• AXC-5014 - Dazzle It! Tropical Punch Lucite Chain, Oval Cable Links 40x22mm, 15 Inches, Amazonia
  Project uses 1 piece. You will need 1 package.


• FCL-2573 - Bright Gold Plated Lobster Clasps Extra Large 23mm (2)
  Project uses 1 piece. You will need 1 package.


• FJR-5166 - 22K Gold Plated Open Jump Rings 6mm 18 Gauge (50)
  Project uses 1 piece. You will need 1 package.


• FJR-8002 - Open Jump Rings, 20mm Diameter 2.5mm Thick, 4 Pieces, Gold Plated
  Project uses 4 pieces. You will need 1 package.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5603 - CHP Milano Heavy Duty Flush Cutter - Cuts Up To 2.5mm Copper Wire