Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
This design measures approximately 20 inches. To modify the length, simply adjust the length of chain used.
- Begin by cutting off 19 inches of chain using your flush cutters.
- Then find the center of the chain, open one jump ring and attach it around the center of the chain and to the pendant. Close the jump ring.
- Move to one side of the chain and attach one jump ring to the end link and to one end of the magnetic clasp. Close the jump ring. Then move to the other side of the necklace and repeat.
WHAT YOU'LL NEED: (scroll down for purchase options)
- CHA-0430 - Gold Plated Figaro Chain, 5mm, by the Foot
Project uses 19 Inches. You will need 2 packages.
- PNT-454 - Metal Pendant, Oval Scroll Bezel with Crystal 21.5x14mm, 1 Piece, Antiqued Gold Plated, By TierraCast
Project uses 1 piece. You will need 1 package.
- FCL-0003 - Magnetic Clasps, Starburst 11x17mm, 1 Set, Antiqued Gold Plated, By TierraCast
Project uses 1 piece. You will need 1 package.
- FJR-5250 - 22K Gold Plated Open Jump Rings 5mm 20 Gauge (100)
Project uses 3 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5511 - The Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - The Beadsmith Jewelry Fine Round Nose Micro Pliers