Retired - Yoga Retreat Orange Knot Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut 18 inches of your leather cord. Fold the cord in half and find the mid way point. Tie a simple overhand knot so it sits right in the middle. Pull tight.
2. Onto one end of your cord string on 1 seed bead, the hamsa hand charm, and 1 more seed bead. Slide them down so they rest next to knot in the middle. Right after the last seed bead, tie another knot and again pull tight. Always pull your knots tight during this project.
3. Tie another knot approximately 3/4 inch from the knot your just tied. Please refer to photo and you can also create a larger gap too if you like. Next slide onto your cord: 2 seed beads, 1 spacer bead, and 2 more seed beads. Slide these down so they rest right next to the knot you just tied and then tie another knot after them.
4. Repeat the previous step on the other side of your bracelet.
5. Now that the beadwork and knotting is done, you can choose how long you want your bracelet to be. Please note that the clasp and jump rings do add about 1/2 an inch. Lay your bracelet flat on a ruler or wrap around your wrist for sizing. Cut your leather ends to the length you want. I found it easiest to line up the two sides with the charm in the direct center and then cut the cords at the same time so they are even.
6. Place onto an end a fancy crimp cord end with loop. Crimp the center section with your chain nose pliers. Open a jump ring and attach it to the loop as well as one half of your magnetic clasp.
7. Repeat the previous step on the other side of your bracelet.
8. Have fun wearing!

• BCS-9017 - Czech Glass, Bohemian Aged 2/0 Round Seed Beads, 10 Grams, Etched Blue Turquoise and Amber
  Project uses 10 pieces. You will need 1 package.


• BMB-9822 - TierraCast 22K Gold Plated Pewter Nugget Heishe Spacer Beads 5mm (12)
  Project uses 2 pieces. You will need 1 package.


• FCR-3155 - Cord Ends, Fancy Crimp Style with Loop, Fits 1.5mm Cord, 10 Pieces, Gold Tone Brass
  Project uses 2 pieces. You will need 1 package.


• CHY-1509 - Genuine Leather Cord, Round 1.5mm, By the Yard, Orange
  Project uses 18 inches. You will need 1 package.


• FJR-3914 - 22K Gold Plated Open Jump Rings 4mm 20 Gauge 22k Gold Plated (100)
  Project uses 2 pieces. You will need 1 package.


• FCL-6807 - Magnetic Clasp, 6x4.5mm, 4 Clasp Sets, 22K Gold Plated
  Project uses 1 piece. You will need 1 package.


• PND-2240 - TierraCast Pewter Charm, Hamsa Hand with Loop 12.5x7mm, 1 Piece, 22K Gold Plated
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
• XTL-0020 - Baby Wubbers Quality Fine Chain Nose Jeweller's Pliers
• XTL-5450 - Xuron Jeweler's Super Fine Pliers Chain Nose Flat Nose