Retired - Wings of Strength Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Use a pair of chain nose pliers to bend the top scallop on an antique silver plated oval bezel cup out until it sits flat, angling straight up.
2. Place a dab of E6000 glue on the back of a faux turquoise cabochon and press it into place in the bezel cup. Allow the glue to dry thoroughly before continuing.
3. Open up a jump ring using your chain nose pliers and slide on the loop from your bezel cup. Don't close your jump ring just yet.
4. Measure the center point of your finished chain, which should be at 8".
5. Next, slide your open jump ring onto that center link. Close your jump ring using your chain nose pliers.
6. Open up a jump ring with your chain nose pliers and slide it through the hole at the top of your wing pendant. Do this also with your other wing pendant. Do not close the jump rings yet.
7. Next, slide on one of your jump rings onto the third chain link on the right side of your cabochon. Repeat this process on the other side with your other wing pendant. Close the jump rings.
8. Your necklace is now ready.

• AXC-98934 - Silver Plated Drawn Cable Chain Necklace - 4.5x2.5mm Links 16 Inches Long
  Project uses 1 piece. You will need 1 package.


• FJR-5219 - Silver Plated Open Jump Rings 6mm 20 Gauge (50)
  Project uses 3 pieces. You will need 1 package.


• PND-6759 - Nunn Design Antiqued Silver Plated Oval Bezel Cup Pendant Lace Edge 18x13mm x2
  Project uses 1 piece. You will need 1 package.


• SPCB-348 - Faux Blue Turquoise W/ Matrix Glass Cabochon 18x13mm Oval (1)
  Project uses 1 piece. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.


• PND-5592 - TierraCast Antiqued Silver Plated Lead-Free Pewter Wing Charms 28mm (2)
  Project uses 2 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose