Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Add a few dabs of E-6000 glue into the bezel of your TierraCast connector link. Gently place your Austrian crystal patina chaton on top. Set aside to dry.
- Using your chain nose pliers, open your earring hook (how you would a jump ring) and slide it onto the top link of your connector link and close.
- Next, open a silver plated jump ring using your chain nose pliers and slide on the lucite pendant and also the bottom link from your connector link and close.
- You're done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- FCO-3084 - TierraCast Rhodium Plated Connector Link Beaded Edge Setting For Austrian crystal 12mm Rivoli (2)
Project uses 2 pieces. You will need 1 package.
- SWCR-1000 - Austrian Crystal, 1122 Rivoli Chatons 12mm, 4 Pieces, Crystal Black Patina F
Project uses 2 pieces. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
- BCP-31454 - Vintage Hand Cut Czech Glass, Faceted Antique Cut Pendant 25mm, 1 Piece, Jet Black
Project uses 2 pieces. You will need 2 packages.
- FJR-5479 - Silver Plated Open Jump Rings 8mm 20 Gauge (50)
Project uses 2 pieces. You will need 1 package.
- FEA-3015 - Silver Plated Fishhooks Earring Hooks (50)
Project uses 1 pair. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose