Retired - Turquoise Drops Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Use a pair of chain nose pliers to bend the top scallop on an antiqued silver plated oval bezel cup out until it sits flat, angling straight up. Repeat this step with a second antiqued silver plated bezel cup.
2. Place a dab of E6000 glue on the back of a faux turquoise cabochon and press it into place in a bezel cup. Repeat this step again with a second bezel cup.
3. Allow the glue to dry thoroughly before continuing.
4. Next, flip over your first bezel cup and place a dab of glue on the back. Take your second bezel cup, and glue it back to back to the first bezel cup. Make sure your flatten scallops from the first step line up. Set aside to dry.
5. Slide a jump ring onto your kidney shaped wire earring.
6. Open up a second jump ring and slide it through your first jump ring and also through the two scallops you bent up in the first step.
7. Your earring is now ready.

• SPCB-348 - Faux Blue Turquoise W/ Matrix Glass Cabochon 18x13mm Oval (1)
  Project uses 4 pieces. You will need 4 packages.


• PND-6759 - Nunn Design Antiqued Silver Plated Oval Bezel Cup Pendant Lace Edge 18x13mm x2
  Project uses 4 pieces. You will need 2 packages.


• FEA-6710 - Silver Plated Earring Hooks Kidney Wires 47mm (10 Pairs)
  Project uses 2 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.


• FJR-5219 - Silver Plated Open Jump Rings 6mm 20 Gauge (50)
  Project uses 4 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose