Retired - The Royal Treatment Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Use a pair of chain nosed pliers to open a 6 mm, 20 gauge antique silver plated jump ring. Place a 13 mm antique silver plated Nunn Design square crown pendant on the jump ring, and then place an 18 mm Vintaj Natural Brass etched square pendant charm behind it on the ring. Make sure that the Nunn Design pendant is facing crown side up. Close the jump ring.
2. Cut an 18" length of 2 mm antique silver plated round rolo chain with a pair of flush cutters.
3. Thread the length of chain through the 6 mm jump ring holding the pendants.
4. Use a 4 mm, 21 gauge antique silver plated jump ring to attach a 12 mm antique silver plated lobster clasp to one end of the chain, and attach a second 4 mm jump ring to the other end of the chain.

• CHA-9705 - Antiqued Silver Plated Round Rolo Chain 2mm Bulk By The Foot
  Project uses 2 feet. You will need 2 packages.


• FCL-2527 - Antiqued Silver Plated Sleek Lobster Claw Clasps 12mm (6)
  Project uses 1 piece. You will need 1 package.


• FJR-3092 - Antiqued Silver Plated Open Jump Rings 4mm 21 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• FJR-3094 - Antiqued Silver Plated Open Jump Rings 6mm 18 Gauge (50)
  Project uses 1 piece. You will need 1 package.


• PND-6908 -
  Project uses 1 piece. You will need 1 package.


• PND-7126 - Vintaj Natural Brass Etched Square Toggle Pendant Charm 18mm (1)
  Project uses 1 piece. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex