Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
Begin by using a pair of round nose pliers (XTL-0034) to gently curl down the points on each of the Arte Metal Decorivets, so that they form loops on the underside of each. Set these aside.Cut eight pieces of 20 gauge wire that are roughly two inches long each. Create a simple loop on one end of each. Thread a 6mm white jade onto each piece of wire, creating another wrapped loop on the opposite end after you have done so.Opening and closing the loops at either end of each link, using the same method you would use to open and close a jump ring, link together the bracelet in this order: three white jade links, one small diamond decorivet link, one white jade link, the large diamond decorivet link, one white jade link, one small diamond decorivet link, and three white jade links.To one end of the bracelet add the bar half of the toggle clasp. To the other end of the bracelet add the circle part of the toggle clasp.Note: the overall length of this bracelet is 7 1/4 inches.
WHAT YOU'LL NEED: (scroll down for purchase options)
- SPJD-46 - White Jade Serpentine 6mm Round Beads - One 15 Inch Strand
Project uses 8 pieces. You will need 1 package.
- FCO-5206 - Vintaj Arte Metal Decorivet Marcasite Diamond 30x20mm
Project uses 1 piece. You will need 1 package.
- FCO-5207 - Vintaj Arte Metal Decorivet Marcasite True Diamond 16mm
Project uses 2 pieces. You will need 1 package.
- FCL-7703 - TierraCast Black Finish Pewter Sleek Wrap Toggle Clasp 12mm (1)
Project uses 1 piece. You will need 1 package.
- WCR-2030 - Artistic Wire, Silver Plated Craft Wire 20 Gauge Thick, 6 Yard Spool, Tarnish Resistant Silver
Project uses 16 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-0034 - Wubbers Classic Series Round Nose Quality Jeweller's Pliers