Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Cut a 12 inch length of your beading wire. Place a bead stopper on one end leaving a tail of about 2 inches.
- String onto your wire:
- 1 crimp tube
- 1 Austrian crystal 6mm rose round bead.
Now string and repeat the following pattern 5 times: - 1 Austrian crystal 4mm crystal bicone bead
- 1 Austrian crystal 6mm rose roundl bead
- 1 Austrian crystal 4mm crystal bicone bead
- 1 scalloped bead cap
- 1 cultured coin pearl in heliotrope purple
- 1 scalloped bead cap
- Now string onto your beading wire:
- 1 Austrian crystal 4mm crystal bicone bead
- 1 Austrian crystal 6mm rose round bead
- 1 Austrian crystal 4mm crystal bicone bead
- 1 Austrian crystal 6mm rose round bead
- 1 crimp tube
- Thread one end of your wire through the loop on one section of your toggle clasp. Thread the wire back through your crimp tube and a couple of the beads next to it. Pull snug and crimp the crimp bead. Cut off excess beading wire.
- Remove the bead stopper on the other end of your strung beads and repeat the above step with the other half of your toggle clasp.
- Have fun beading!
WHAT YOU'LL NEED: (scroll down for purchase options)
- FCR-1215 - Beadalon Silver Plated Crimp Tubes 2x1.8mm 1.3mm ID (75 Beads)
Project uses 2 pieces. You will need 1 package.
- XCR-67513 - Beadalon Wire Standard Bright 7 Strand .015 Inch / 30 Feet
Project uses 12 inches. You will need 1 package.
- SWC-06117 - Austrian Crystal, 5000 Round Beads 6mm, 10 Pieces, Rose Satin
Project uses 8 pieces. You will need 1 package.
- BMB-3287 - TierraCast Fine Silver Plated Pewter Scalloped Bead Caps 3.5mm (12)
Project uses 10 pieces. You will need 1 package.
- SWBI-1402 - Austrian Crystal, 5328 Bicone Beads 4mm, 24 Pieces, Crystal AB 2X
Project uses 12 pieces. You will need 1 package.
- FCL-3032 -
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-3000 - Bead Stopper- Stop Beads Sliding Off Stringing Material
- XTL-5200 - Standard Size Beading Crimping Pliers (For 2x2mm & 2x1mm Crimp Beads)
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex