Silver Spikes Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by cutting an 18" length of chain with your flush cutters. Remember to leave the small connecting jump rings (that come in between each bar link) still in tact on either end of your chain.
2. Next, using your chain nose pliers, open the last jump ring on one end of your chain length. Attach the loop of your silver plated clasp and close.
3. Lay your chain length flat on your work place. Using your chain nose pliers, open a 4mm silver plated jump ring, slide on the loop from one silver spike button and attach it onto the small jump ring that is in between the bar links at the center point of your chain.
4. Repeat this process, attaching a total of 20 silver spike beads via their open jump rings and close.
5. Close your clasp (onto the last jump ring on the other side of chain) & you're done!

• CHA-08039 - Silver Plated Bulk Chain, Long Bar Links 13.5mm, 1 Foot
  Project uses 18 inches. You will need 2 packages.


• CRY-1026 - Crystaletts Micro Spike Buttons, 4x6mm, 20 Pieces, Rhodium Plated Plated
  Project uses 20 pieces. You will need 1 package.


• FJR-5454 - Silver Plated Open Jump Rings 4mm 22 Gauge (50)
  Project uses 20 pieces. You will need 1 package.


• FCL-2528 - Silver Plated Sleek Lobster Claw Clasps 9mm (10)
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose