Scotland's Thistle Ring

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by cutting out the square image you want to use. I choose the thistle. Figure out which part of the picture you would like to use and before you glue, test it out by placing the glass dome down on the paper.
2. Place a small dab of Diamond Glaze onto the back of the glass cabochon and carefully place the cabochon on to your paper. Please refer to the video: How to Make a Glass Dome Paperweight for an example using this technique. Press firmly to make sure there are no air bubbles and to insure the glaze goes to the edges.
3. Once the glaze has dried, trim the edges of the paper.
4. Place a dab of Crafters Pick glue on the back of the paper. Carefully center it in bezel cup of the ring finding. Press down and if any glue spills out the sides wipe it up immediately.
5. Let dry completely before wearing.

• FRG-0772 - Antiqued Brass Round Bezel Filigree 20mm Adjustable Ring (1)
  Project uses 1 piece. You will need 1 package.


• BGL-9003 - Clear Czech Glass Cabochon Round Beads Crystal Magnify 20mm (2)
  Project uses 1 piece. You will need 1 package.


• XTL-9463 -
  Project uses 1 piece. You will need 1 package.


• XTL-1020 - JudiKins Diamond Glaze Water Based Adhesive (2 Fl. Oz.)
  Project uses 1 piece. You will need 1 package.


• XTL-1026 - Crafter's Pick The Ultimate Permanent Glue Cement Adhesive 4 OZ
  Project uses 1 piece. You will need 1 package.

• XTL-5700 - Fiskars 5 Precision Tip Scissors - Super Sharp