Retired - Roxanne Wrap Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Take the medium gray studded faux suede cord from the package. Using flush cutters, cut a 24 inch length of cord.
2. Place a few drops of Super New Glue into the well of one silver cord end. Insert one end of the length of faux suede cord and let it dry for a few minutes.
3. Repeat step 2 to attach the second cord end to the other end of the cord.
4. Open a jump ring. Slide it through the loop of one cord end, and also slide on the loop of your clasp. Close the jump ring.
5. Open another jump ring. Slide it through the loop of the other cord end on the other end of the bracelet. Close the jump ring.
6. Wrap the bracelet 4 times around your wrist and close the clasp. Enjoy!

• XCR-1341 - BeadSmith Studded Faux Suede, Jewelry Cord Assortment 5mm Wide, 8 Meters Total, Cools Mix
  Project uses 24 inches. You will need 1 package.


• FCO-9321 - Antiqued Silver Square Cord Ends For Regaliz 5mm Flat Cord 10.5x7.5mm - 2 Pcs
  Project uses 2 pieces. You will need 1 package.


• XTL-1059 - Eurotool Super New Glue - Heavy Duty Adhesive - 3 Gram Bottle
  Project uses 1 piece. You will need 1 package.


• FCL-2540 - Antiqued Silver Plated Sleek Lobster Claw Clasps 15mm (6)
  Project uses 1 piece. You will need 1 package.


• FJR-2066 - Nunn Design Antiqued Silver Plated Open Jump Rings Twist 8.5mm 17 Gauge (10)
  Project uses 2 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex