Retired - Red Regaliz Faux Leather Bangle

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by adding a few drops of Super New glue into one of your silver plated cord ends.
2. Carefully place one end of your pre-cut 7" length of red Regaliz braided cork into the cord end. (This glue is quite strong so be careful not to get any on your fingers.) Hold in place for a few seconds.
3. Repeat this process with a second cord end and the other end of your Regaliz braided cork. Set aside.
4. Slide on a turquoise gemstone bead onto a silver plated head pin. Create a simple wire loop with your round nose pliers and snip off any excess wire using your flush cutters. Once your bead is on, create another simple wire loop. Snip off any excess wire with your flush cutters.
5. Next, with your chain nose pliers open a silver plated jump ring and slide it onto a simple wire loop from one side of your turquoise gemstone bead. Before closing the jump ring, also slide on the loop from on of your cord ends and close.
6. Repeat this process with a second jump ring and your second cord end.
7. That's it!

• SPTU-27 - Large Turquoise Round Pendant Beads 30mm Stabilized (x2)
  Project uses 1 piece. You will need 1 package.


• CHX-1187 - Regaliz Portuguese Cork Cord, Round and Braided 6mm, By The Inch, Red
  Project uses 7 inches. You will need 7 packages.


• FCR-1607 - Beadsmith Silver Plated Barrel Cord Ends With Ring 12mm Long - Fits Up To 6.5mm Cords (4)
  Project uses 2 pieces. You will need 1 package.


• FHP-05327 - Silver Plated Head Pins - 22 Gauge 3 Inches (25)
  Project uses 1 piece. You will need 1 package.


• FJR-5467 - Silver Plated Open Jump Rings 6mm 21 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• XTL-1059 - Eurotool Super New Glue - Heavy Duty Adhesive - 3 Gram Bottle
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose