Retired - Printemps Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. First, line up the stampings vertically, so that the long sides of the stampings are touching. Connect the stampings using two jump rings through both of the sets of touching loops.
2. Once all of the stampings are connected add two jump rings, one per end loop, at both ends of the bracelet.
3. Using a jump ring attach the extender chain to the two jump rings at one end of the bracelet.
4. Using another jump ring attach the lobster clasp to the two jump rings at the other end of the bracelet.
5. Spread a small amount of E6000 onto the backs of the flower cabochons, and press them onto the centers of the stampings, alternating green and blue.
6. Set aside to dry for at least twenty-four hours.

• AXC-2727 - Silver Plated Chain Necklace Extender With Ball End - 3 Inch (x10)
  Project uses 1 piece. You will need 1 package.


• FCL-2522 - Beautiful Silver Plated Curved Lobster Clasps 15mm (10)
  Project uses 1 piece. You will need 1 package.


• BCP-4504 - Lucite Cabochons 3-D Dahlia Flower Olive Green 13mm (4)
  Project uses 4 pieces. You will need 1 package.


• BCP-4197 - Lucite Flower Cabochons Dahlia Chrysanthemum Mum Turquoise Blue 10mm (6)
  Project uses 4 pieces. You will need 1 package.


• FJR-5400 - TierraCast Silver Plated Brass Oval Jump Rings 4mm 20 Gauge (50)
  Project uses 34 pieces. You will need 1 package.


• FCO-7002 - Silver Plated Small Oval Filigree Stamping 26mm x 19mm (4)
  Project uses 8 pieces. You will need 2 packages.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.