Retired - Osiris Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by cutting 14" of beading wire using your flush cutters. I have included 3" on either side to allow for crimping.
2. Next, cut 9" of chain using your flush cutters. (You can remove links later to adjust the bracelet size)
3. Add a crimp bead to one end of your length of wire and pass it through one of the jump rings that comes with your antiqued silver clasp. Take the wire back through the crimp bead. Pull snug and crimp your crimp bead with your crimping pliers. Snip off any excess wire using your flush cutters.
4. You will now begin adding your chain and Austrian crystal pearls onto the beading wire.
5. Slide on the last link from one end of your length of chain onto your beading wire.
6. Next, slide on an Austrian crystal pearl.
7. Take your chain length and carefully wrap 7 links around the pearl, sliding the 7th chain link back through the beading wire. Make sure the chain is resting tightly around the pearl. See photo for assistance.
8. You will continue this step, alternating between the top and bottom sides of the next 11 Austrian crystal pearls you add on. Remember you can stop at any time to customize the length of your bracelet.
9. Once you reach the end of your desired bracelet length, add on another crimp bead. Take your beading wire through the second jump ring that comes with your clasp and back again through the crimp bead. Pull snug. Crimp the crimp bead using your crimping pliers. Snip off any excess wire using your flush cutters.
10. Close your clasp and you're done!

• XCR-67833 - Beadalon Wire Satin Silver 7 Strand .018 Inch / 30Ft
  Project uses 14 inches. You will need 1 package.


• SWP-12563 - Austrian Crystal, 5810 Round Faux Pearl Beads 12mm, 4 Pieces, Scarabaeus Green
  Project uses 12 pieces. You will need 3 packages.


• CHA-0423 - Antiqued Silver Plated Bulk Chain, 4x3mm Venetian Box Links, Sold By The Foot
  Project uses 9 inches. You will need 1 package.


• FCL-1662 - Large Oval Lobster Clasp, with 2 Jump Rings 20x15mm, 1 Set, Antiqued Silver Plated
  Project uses 1 set. You will need 1 package.


• FCR-1715 - BeadSmith Crimp Tubes, 2x2mm, 100 Pieces, Silver Plated
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5200 - Standard Size Beading Crimping Pliers (For 2x2mm & 2x1mm Crimp Beads)
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose