Noodle Bead Bracelet in Purple

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut five 6" pieces of purple waxed cotton cord. I used a pair of flush cutters to get a nice clean cut.
2. Group your cords together with the ends even and apply some E6000 glue to the ends, then fit them into a silver plated cord end for 4mm cord. Push them all the way in and then clean off any excess glue. Allow the glue to dry before continuing.
3. Slide a 3 x 50mm silver plated curved noodle bead onto each cord.
4. Attach the loose ends into a second cord end in the same manner as you did the first. Allow the glue to dry before continuing.
5. Use a 4mm, 22 gauge silver plated jump ring to attach each cord end to one side of a silver plated magnetic clasp.
6. Allow all glue to dry thoroughly before wearing.

• BMB-4074 - Silver Plated Long Curved Noodle Tube Beads 3mm x 50mm (10)
  Project uses 5 pieces. You will need 1 package.


• FCR-1604 - Beadsmith Silver Plated Barrel Cord Ends With Ring 10mm Long - Fits Up To 4mm Cords (4)
  Project uses 2 pieces. You will need 1 package.


• FJR-3911 - Silver Plated Open Jump Rings 4mm 20 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• FCL-6808 - Silver Plated Magnetic Clasps 6 x 4.5mm (4 Sets)
  Project uses 1 piece. You will need 1 package.


• XCR-4311 - Waxed Cotton Cord 1.5mm Round - Dark Lavender (5 Meters/16.5 Feet)
  Project uses 30 inches. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 tube. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex