Retired - Mosaic Tiled Tila Ring

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Take a small amount of E6000 glue, and using a toothpick or scrap wire as an applicator, smear the glue on the flat surface of the bezel's interior surface. So that you do not need to rush, only smear over half of the surface to begin with.
2. Starting along the edge, begin placing your Tila Beads in a random pattern. See photo.
3. 5 Tila Beads will fit length wise and 5 will fit width wise in the square ring. A total of 25 Tila Beads will be used in this project.
4. After you have tiled all the area where glue was present, take your applicator and apply glue to the remaining area.
5. Finish setting your Tila Beads into the glue.
6. When all the beads have been placed, pat their tops down with your finger so that all the beads are firmly set into the glue.
7. Let dry in an upright position overnight.

• DBT-2005 - Miyuki Tila 2 Hole Square Beads Matte Metallic Copper 7.2 Grams
  Project uses 13 pieces. You will need 1 package.


• DBT-4013 - Miyuki Tila 2 Hole Square Beads Matte Black Ab 7.2Gr
  Project uses 12 pieces. You will need 1 package.


• FRG-0857 - Bright Silver Tone Brass Square Bezel Adjustable Ring 26mm (1)
  Project uses 1 piece. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.