Retired - More Cowbell Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by cutting a 1 inch length of your antiqued silver plated chain, making sure to not have any broken links at the ends.
2. Next, open up the loop from your antiqued silver earring hook (how you would a jump ring) and slide on the last link from one end of your chain. Close the earring loop back up.
3. With your chain nose pliers, open up an antiqued silver plated jump ring and slide on the last link from the other end of your chain length. Before closing, also slide on the small loop that is at the top of your cow bell charm and close.
4. That's it!

• CHA-9813 - Nunn Design Antiqued Nunn Design Silver Plated Oval Cable Chain 3mm By The Ft
  Project uses 2 inches. You will need 1 package.


• FEA-3081 - Antiqued Silver Plated French Wire Earring Hooks 16mm (25 Pairs)
  Project uses 2 pieces. You will need 1 package.


• PND-5824 - Antiqued Silver Plated Small Cow Bell Charms 17.2mm (1)
  Project uses 2 pieces. You will need 2 packages.


• FJR-3094 - Antiqued Silver Plated Open Jump Rings 6mm 18 Gauge (50)
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose