Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
Please note that the clasp has changed slightly on this design from the one pictured. All the other beads remain the same.
- Cut 15 inches of beading wire. Place a bead stopper on one end, 4 inches from the tail. String on 1 crimp bead.
- String your beads in the following order: 1 black bicone, 3 red bicones, 1 black bicone, 1 ladybug bead. Repeat this sequence 4 more times.
- Next, string on the following beads: 1 black bicone, 3 red bicones, 1 black bicone, 1 crimp bead.
- Take your beading wire and thread it through the loop on one half of your clasp. Loop it back through your crimp bead and pull snug. Crimp your crimp bead and trim off excess wire. Place a crimp bead cover over your crimp bead.
- Go back to the other side of your bracelet and remove the bead stopper. Now repeat the previous step on this side of the bracelet with the other half of your toggle clasp. All done! Enjoy!
WHAT YOU'LL NEED: (scroll down for purchase options)
- BMB-3407 - TierraCast Fine Silver Plated Pewter Ladybug Beads 10mm (2 Pieces)
Project uses 5 piece(s). You will need 3 package(s).
- PRES-5328-JET4 - PRESTIGE Crystal, #5328 Bicone Bead 4mm, Jet (1 Piece)
Project uses 12 piece(s). You will need 12 package(s).
- PRES-5328-SIALT5 - PRESTIGE Crystal, #5328 Bicone Bead 5mm, Light Siam (1 Piece)
Project uses 18 piece(s). You will need 18 package(s).
- FCL-7024 - TierraCast Pewter Toggle Clasps, Scroll 12.5mm, Silver Plated (1 Set)
Project uses 1 piece(s). You will need 1 package(s).
- XCR-69513 - Beadalon Wire Standard Bright 19 Strand .015 Inch / 30Ft
Project uses 15 inches. You will need 1 package(s).
- FCR-1093 - Crimp Bead Covers, 3mm, Silver Plated (50 Pieces)
Project uses 2 piece(s). You will need 1 package(s).
- FCR-1715 - The Beadsmith Crimp Beads, Tube 2x2mm, Silver Plated (100 Pieces)
Project uses 2 piece(s). You will need 1 package(s).
RECOMMENDED TOOLS:
- XTL-5200 - Standard Size Beading Crimping Pliers (For 2x2mm & 2x1mm Crimp Beads)
- XTL-5450 - Xuron Jeweler's Super Fine Pliers Chain Nose Flat Nose
- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire (1 Piece)
- XTL-114 - Bead Buddy, Bead Bugs Bead Stoppers Regular Size (4 Pieces)