Retired - Lovely Daisies - Set of 6 Hair Pins

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by taking the cap off of your tube of E6000. Turn the cap upside down and puncture the tube's protective seal with the pointed tip inside the cap.
2. Squeeze a small dab of E6000 glue onto the flat glue-on tab of a bobby pin. Line up the flat tab of the bobby pin with the center backside of a daisy and press into place.
3. Repeat the above step with all your daisies and bobby pins.
4. Let dry for 24 hours.

• BCP-4513 - Vintage Look Lucite Cabochon Carved White Daisy Flower 25mm (2)
  Project uses 2 pieces. You will need 1 package.


• BCP-4455 - Lucite Flower Cabochons Carved Pink Daisy 27mm (2)
  Project uses 2 pieces. You will need 1 package.


• BCP-4456 - Lucite Flower Cabochon Carved Lavender Purple Daisy Flower 27mm (2)
  Project uses 2 pieces. You will need 1 package.


• FCO-9057 - White Enamel Metal Bobby Pins With 8mm Pad For Gluing (10 Bobby Pins)
  Project uses 2 pieces. You will need 1 package.


• FCO-9055 - Neon Pink Enamel Metal Bobby Pins With 8mm Pad For Gluing (10 Bobby Pins)
  Project uses 2 pieces. You will need 1 package.


• FCO-9058 - Yellow Enamel Metal Bobby Pins With 8mm Pad For Gluing (10 Bobby Pins)
  Project uses 2 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.