Retired - Locket of Love Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Using your flat nose pliers, open a Nunn Design etched jump ring and slide it onto the last link on one side of your 24� long chain. Close the jump ring.
2. Open up another jump ring and slide it onto the last link on the other end of chain. Also slide on the loop from your Nunn Design clasp and close.
3. Next, open up another jump ring and slide it through the loop on the top of your Nunn Design locket pendant. Before closing, find the center link on your chain (at the 12 inch mark) and slide on the jump ring and close.
4. Cut a 12 inch length of velvet ribbon with your flush cutters.
5. Take your ribbon length to where your two chains meet above your Nunn Design locket pendant and make a simple bow. Cut off any additional length (I left about 1� long lengths) and cut the ends at a diagonal leaving 2 decorative points on each length. See photo for placement assistance.
6. Next, open up another jump ring, slide on your gold plated Nunn Design heart puff charm and slide it onto the 15th chain link on the left side of the necklace. See photo.
7. Lastly, add in a 33mm sized photo for a personalized touch.
8. You're done.

• CHA-9806 - Nunn Design Antiqued Gold Plated Textured Cable Chain By The Foot
  Project uses 24 inches. You will need 2 packages.


• XCR-49024 - Gorgeous Necklace Flat Velvet Ribbon 3/8 Inch Antique Gold (3 Yards)
  Project uses 12 inches. You will need 1 package.


• FCL-7525 - Nunn Design Antiqued 24kt Gold Plated Lobster Clasps 15mm (2)
  Project uses 1 piece. You will need 1 package.


• PND-6814 -
  Project uses 1 piece. You will need 1 package.


• FJR-2069 - Nunn Design Antiqued 24kt Gold Plated Open Jump Rings Etched 6.5mm 17 Gauge (10)
  Project uses 4 pieces. You will need 1 package.


• PND-6594 - Nunn Design Antiqued Gold Plated Pewter Large Puff Heart Pendant 14mm
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5700 - Fiskars 5 Precision Tip Scissors - Super Sharp