Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Cut two lengths of chain at 7 3/4" long.
- Add a jump ring to either end of both lengths of chain.
- Add one end of piece of chain to two of the holes on either side of a point on the filigree stamping.
- To the opposite end of one of the lengths of chain add a spring ring clasp.
- Using a toothpick, dab a small amount of E6000 glue on to the backs of the rhinestones and position them in the center of the filigree stamping in this way: place one rhinestone in the very middle and the remaining rhinestones surrounding the center one. The glue will set in about six minutes, and full curing occurs within twenty-four hours.
WHAT YOU'LL NEED: (scroll down for purchase options)
- FCL-01051 - Sterling Silver Spring Ring Round Clasps Closed Ring 5mm (10)
Project uses 1 piece. You will need 1 package.
- FJR-03046 - Sterling Silver Open Jump Rings 4mm 21 Gauge (20)
Project uses 4 pieces. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
- PND-5415 - Antiqued Silver Plated Filigree Stamping - Ornate Square Flower 46mm (1)
Project uses 1 piece. You will need 1 package.
- CHA-1808 - Sterling Silver Cable Chain 2.75mm Textured Bulk By The Foot
Project uses 2 feet. You will need 2 packages.
- SWF-42000 - Austrian Crystal, Round Flatback Rhinestone SS20 4.6mm, 50 Pieces, Crystal
Project uses 7 pieces. You will need 1 package.